Motorcycle Clothing, Parts & Accessories

01792 22 44 30

Kreem Blueshield 16fl.oz

More Views

Kreem Blueshield 16fl.oz

An internal exhaust pipe coating that shields against pipe blueing on properly tuned engines – 16 fl. oz. (1 pint)
Blue Shield is an internal exhaust pipe sealant that is designed to prevent ‘pipe blueing’ on properly tuned motors. Since ‘pipe blueing’ is cause by excessive heat it may still occur if an engine is not in proper tune of if the carburetor is jetted too lean. Slight blueing or discoloration may occur on pipes with extremely sharp bends coming from heads.
NOTE: Read instructions thoroughly before applying Blue Shield. For use on new exhaust pipes only. Inside of pipes must be free from dirt and residue. Clean with alcohol or solvent.
Important: If coating a pipe with muffler, special care must be taken to ensure that Blue Shield does not enter muffler baffle.



Blue Shield is designed for use on new pipes only. Inside of pipes must be clean and free from oil. If dirt and oil are present, clean with alcohol or solvent. Do not use alcohol or solvent on pipes with fiberglass baffles.

  • Shake of stir coating cement well.
    • Cover one end of pipe with duct tape. (If coating pipes with muffler, cover muffler end first.)
      • Pour contents of bottle into open end of pipe. (If coating pipes with muffler, hold pipe at an adequate angle to ensure no Blue Shield enters the muffler baffle.)
        • Cover open end of pipe with duct tape and rotate until inside of pipe is evenly coated.
          • Remove tape and drain excess Blue Shield, collecting it for reuse. Hang pipe with filler end down for 1 hour. Air dry in warm, dry area of 6-12 hours, or oven dry at 150-175 degrees for 1 hour.
            • Apply a second coat following the same steps.
              • Remove any excess Blue Shield on outside of pipe by knocking off with a blunt object.
                • Wash hands and clothing thoroughly after applying Blue Shield.
                  • Install tail pipe assembly.
                    • NOTE: Generally discoloration of chrome tail pipes occurs in the first 1-2 feet of the pipe. A uniform, dual coating in this area will minimize the potential of chrome discoloration under normal vehicle operating conditions.

Additional Information

Additional Information

Manufacturer Kreem
SKU 680736
Manufacturers Part No. 680736
Product Group Workshop Consumables
Master Card

M&P Direct Ltd. Phoenix Way, Garngoch, Gorseinon, Swansea. SA4 9HN.
Registered in England & Wales No. 3928542. VAT No. 779 4632 75.
M&P Direct Ltd. are regulated by the Financial Conduct Authority, Consumer Credit Licence Number 678577.