EBC MX brake disc for offroad motorcycles. MADE IN UK. The aim of the
development is to improve the braking behavior compared to the original
brake disc. EBC uses HPSR steel with a low carbon content, which has an
18% higher friction coefficient. This steel is significantly more
resistant to rust than cast steel. In addition, the entire surface is
protected by a 3 micron thick zinc layer, which is braked in the area of
the brake lining contact zone when braking. It is only in this area
that it is easier to form rust rust with a longer service life. The
brake discs are drilled in the bird's swing signal to get rid of the
rainwater and brake dust with as few holes as possible while
simultaneously optimizing the brake disc. The fewer drill holes are
installed, the better the wet braking behavior and the lower the wear.
-
Rigid brake disc.
-
Made from heat-treated carbon steel.
-
Braked surface with optimized hole pattern.
-
Radially ground.
-
Galvanized to protect against corrosion.
-
EBC recommends EBC Organic TT brake pads or for sporty drivers EBC
sintered brake blocks in R or MXS mixture.
-
Stand-alone design.
-
The thickness of the brake disc may vary from the original part.
